However, rarely salon business which also perform inspection and maintenance services as a whole seat. In fact, efforts to check the real condition and lap seat backrest to the integrity of the framework is clearly a part missing that should be done.
Upholstery care requires a long time, therefore recommended that you select an empty day to perform this operation. Here are some primary care needs to be done against the seat, for obtaining the shift comfort, set, until your sitting position.
- Remove the entire seat
Treatment should begin with the bare seat all your car seat. Front seat was removed at the order attached to the floor of the car. While the rear seat back support should also be removed. As for the type jeep, when the rear seat is still not the standard required removal.
Jeep rear seat, usually only requires provision of a lubricant, so that the folded part is secured affairs poses no difficulty. What also needs to be checked in the back seat of the jeep is penguncinya belt, is still in good condition.
- Check the integrity of the framework
After the front seat is below, check the integrity of the frame holder. The trick, try to pull forward the right side of the back seat and hit the back left side. Repeat with the press and pull the opposite direction. If the order is still good, then the flexibility is still good and there was no strange noises.
Press entire surface of the front seat holder. Generally consists of a front seat and foam. Some cars even use coconut fibers in this PART. When the pressure is felt almost the same in every part, then the front seat of your car is still good. Check the bottom of the well by turning the front seat of your car. Observe whether as still in reasonable condition.
Checking the integrity of the back seat, for the sedan and observed by inverting the base underneath which usually consists of metal plate. Make sure this section does not rust. While commercial car seats are generally similar to the front seat, then the examination can be performed similar to the observation of the front seat.
Examination sedan rear seat backrest, can be done by the same observations stand in the way the back seat of the sedan. However, this section is rarely damaged, so if you do not have weirdness of this section need not be removed.
- Check the condition of the round ottoman
Some types of cars using the system as a means of regulating roller tilt back the car. Examination of this part is more directed to convince the round is still going well. Give this section when oil was less slowly rotating roller.
Similar treatment is required for the inspection type regulator backrest tilt in the form of a lever. Make sure the work shift each time the lever was appointed still good. Damage is usually felt by the slope of the jump sizes were irregular.
- Check the condition and integrity of the rail
This is special for the front seat or middle seat for commercial vehicles. After the seat behind you, make sure the rail is still functioning properly. A good rail is still smooth when it comes to promoting and rewind the seat on it. There are good rail cleaned by using petrol and then back rub grease to smooth the rate of forward and backward seat arrangement.
Never be afraid to disassemble the seat for the benefit of treatment. What is clear is only required removal of a few nuts and bolts for this purpose. bid ()
